1995-1997 JDM RD1 HONDA CRV CV AXLE SET 4x114.3

1995-1997 JDM RD1 HONDA CRV LEFT CV AXLE 4x114.3

Please note: This CV Axle Set is only compatible with the JDM / Japanese spec (RHD) CR-V with wheel bolt pattern of 4x114.3, this does not fit a USDM CR-V.

These are manufactured in house, from new cores. Custom made CV Axle for the JDM Spec CRV, which uses a 26 spline axle, 32mm Nut. This is for 1 Left Side, and 1 Right Side. It is recommended to replace the half-shaft bearing and seal when doing the Left side, we do have those available as well. A press is required to remove the inner bearing from the half shaft. It is also recommended to replace the (2) Transmission Axle seals when removing the axles from the transmission, if yours are original and not been replaced before. Cheap insurance to make sure you won't need to do labor twice to replace those cheap seals before the next time the axles need to be pulled. (Add to checkout).

This CV Set has a 1 year warranty for normal wear and tear, abuse or physical / accidental damage (Like a torn boot) is not warranted. (Note: If you keep replacing axles due to torn CV boots, look into getting some CV Protectors, which can be found on amazon and online, it is a protective sleeve to cover the rubber boot from rocks tearing the boots).

** SHIPPING IS ONLY BY GROUND, WHICH IS USUALLY 2-3 DAYS TO MOST STATES, DUE TO WEIGHT **

** THIS ITEM IS USUALLY IN STOCK, HOWEVER, YOUR ORDER MAY TAKE 3-5 ADDITIONAL DAYS TO PROCESS IF WE ARE ON LOW INVENTORY! **